Influence factors of bearing damage LUNRICATION AND OIL FOR 23048 CCK/W33
We can provide free samples . Please contact Email for any inquiries
Use of the bearing should pay attention to the following items:
One, keep the bearings and the surrounding environment clean
Even the eyes can not see the smile dirt into LUNRICATION AND OIL FOR 23048 CCK/W33the bearing, also increase the bearing wear, vibration and noise.
Two, use the installation carefully
Do not allow powerful punch, does not allow direct percussion bearing with a hammer, not allowed to pass through the rolling pressure.
Installation tool three, use the appropriate, accurate
As far as possible the use of LUNRICATION AND OIL FOR 23048 CCK/W33 special tools, the use of fabric and fiber or something to avoid.
Four, to prevent the corrosion of bearings
Direct hand to take bearings, should wash hands sweat, and coated with high quality mineral oil before operation, during the rainy season and summer with particular attention to anti rust.
However, in some special operating conditions, the bearing can have a longer life expectancy in traditional computing, especially in the light load conditions. These special operating conditions, when the rolling surface (track and rolling) is may cause surface damage a lubricating oil film to LUNRICATION AND OIL FOR 23048 CCK/W33 effectively separate and limit pollutants. In fact, in ideal conditions, the so-called permanent bearing life is possible.
Five, the bearing life
Therefore, in the calculation of bearing size, there must be a clear definition of "life" is a word. All information about the basic dynamic load rating of the general offer, bearing a large enough number of surface based on 90% identical, can reach more than life as the basis.
Different definitions of the bearing life. One of them is "working life", said bearing in the actual working conditions, failure to life before the actual. We must pay attention to, only the individual bearing life was predicted by statistical methods. Life calculation of LUNRICATION AND OIL FOR 23048 CCK/W33 reliability is bearing group and a certain procedure, about 90%. Failure in the actual use are usually not due to fatigue, the situation is more pollution, wear, misalignment, corrosion, or fault holder, lubrication or seal by.