We can provide free samples . Please contact Email for any inquiries

Single cylinder diesel engine tile kilning, available method for grinding shaft tile, when necessary. This method is simple, without removing the cylinder head and piston connecting rod group, also do not need to adjust the valve clearance, saves time and labor. (1) if the crankshaft can not move, can remove the drive belt on the flywheel, flywheel nut lock lever adjustment, will remove the flywheel of the special wrench on the flywheel nut clockwise, hammer percussion wrench handle, general flywheel rotate. (2) remove the gear chamber cover, gear and the back cover, unscrew the nut out of flywheel, flywheel. (3) using a suitable socket wrench screw out the connecting rod screw, turn the crankshaft so that the piston after decompression in the only point, then remove the main bearing cover screws, top of the main bearing cap, stretched out his hand from the rear lid unscrew connecting rod screws, remove the connecting rod cap, pulled out from the machine side of crankshaft, and a wire through the connecting rod big head screw back tie. (4) according to the erosion of the crankshaft to decide how to repair, and the corresponding improvement. (5) by conventional installed after installing crankshaft main bearing crankshaft crank, the backward, and then pull the bundle in the connecting rod big end of the wire, so that the piston connecting rod set down only a little exercise, until the connecting rod and connecting rod shaft neck attached. From the back to the big end of the connecting rod is inserted into the shaft neck and upper tile, roof tile is pressed under the connecting rod cap in hand, then the screw in the connecting rod screws, and then install the main bearing cover. (6) according to the prescribed torque tightening for connecting rod screws, fit back all the removed parts