We can provide free samples . Please contact Email for any inquiries

Failure in the EDA premature bearings all the circumstances, about 16% is due to improper installation or improper installation method by. Different applications may need to properly heat or mechanical, hydraulic device and effectively mounting linear bearings. Select the installation method of the appropriate application will help you to extend the service life of the bearings, cost reduce premature bearings failure and potential failure caused by.
Before installation, usually oil bath heating bearingss. However, this method may be contaminated bearings, premature bearings failure caused by. Today, induction heating is the most commonly used means of heating bearingss, due to its controllability, high efficiency and safety. EDA bearings induction heater application development standard. Straight line bearings induction heater has many functions, help to prevent damage to the bearings heating process.
In fact, if the specific use of each, have taken the bearings life test in sufficient quantities, bearings to verify the suitability of the selected in the economy of time and labor, therefore, the bearings life test is the most necessary or important, before the use case, a method for computing the standard the estimation of EDA bearings life, life, an adequate level of reliability.

Metallurgical quality of EDA bearings material was the main factors affecting the early failure of bearings rotation. With the metallurgical skills (such as vacuum degassing of bearings steel etc.) progress, raw material quality improvement. Raw materials quality factors in the proportion of the bearings failure has obviously decreased, but it is still one of the main factors of bearings failure. Whether it is appropriate that is still the material failure factors needed to consider the linear bearings.
The other, bearings is monitoring the working conditions, have come out in the repair progress bearings effect of the line plan, can receive the twice the result with half the effort. According to the process, equipment and repair the efficient use of things, and to get help bearings factory professional, all contribute to the economic development.
EDA bearings metal corrosion and rust is the point sweat hand, accounted for the vast majority of metal corrosion, can not be avoided in the case of many. Hand sweat will cause corrosion of linear bearings, mainly in the sweat sweat contact surface membrane, the electrochemical reaction and interaction may cause corrosion, but can be avoided, such as gloves, such as professional tools to pick up parts.
Grease works from the ball separation and internal and external raceway formation, oil viscosity, posted on the ball and the raceway surface, consists of inner, outer raceway and ball metal interface separation, reducing the metal surface and prevent air and water corrosion of the metal, to reduce vibration and noise, the linear bearings rotate smoothly.
EDA bearings show advanced fault feature to appear serious faults (usually bearings damage such as axle, burn, sand frame spallation, raceway, beads to wear) most of the time not more than one week, equipment capacity is more big, the faster the speed, the shorter the time interval between. Therefore, in the actual fault diagnosis of rolling bearings fault feature of late, once found, should be decisive judgment linear bearings fault, arrange the repair as soon as possible.