We can provide free samples . Please contact Email for any inquiries

Every aspect of INA bearing quality are good, but the rolling bearings are precision components, its use must be carefully. No matter how high performance of INA bearings, if used improperly, will not get the high performance expectations. Regarding the use of INA bearing the matters needing attention were the following:
(1), keep the INA bearing and the surrounding clean.
Even if is the eye cannot see small dust, will bring bad effect to the INA bearings. So, to keep the surrounding clean, so that dust is not penetrated INA bearings.
(2) use, circumspect.
In use and INA bearing a strong impact, will have scars and indentation, became the cause of the accident. In severe cases, will crack, fracture, so be careful.
(3), using the right tools.
To avoid the existing tools instead, you must use the appropriate tool.
(4), to the attention of INA bearing corrosion.
When operating the INA bearings, hand Khan will become the cause of rust. To note that the clean hands operation, the best to wear gloves.
(5) the heat to the surrounding radiation. Guide magnet, induction coil placed on the insulating paint and glass fiber cloth etc.. This form of less heat loss, heat evenly, has little effect on the sensor burnout.
(6) the cooling water heat. Cooling of this part of the sensor, the safe operation of induction heating. Study found that, in the low temperature 0-180 degrees, intake, show good heat exchange cooling water, water smooth, no water temperature; more than 180. , because the flow path length, water temperature, water temperature, the heat exchange changes, because the sensor can easily lead to a site (such as 225. On the part of) temperature to rise, this is the main combustion induction coil.
(7) induction coil heat transfer plates, current density, plate, large section and the temperature of the water is low, in the area of the area of heat transfer plate, coil. 0 to 90 degrees and 270 degrees away from the -360 part of the induction coil plate nearby, good thermal conductivity; away from the plate, poor thermal conductivity, the induction coil 90 to 270 pieces, so that the local induction coil temperature more easily occur in this part of the phenomenon of burning coil. Comparison of different parts of the heat flux of induction coil. Loop 225 degrees in the region near the heat, and the savings, the difference between the area prone to induction coil burning large.