We can provide free samples . Please contact Email for any inquiries

FAG Bearings sub-routine inspection of preparatory work to complete the following six steps
1. Turn the outer ring, and carefully wash the cage, rolling elements and raceways at the junction, need to be thoroughly cleaned of any previously hidden part of the oil residue. FAG Bearings should be attached to the neighbor rinse dry, clean lined neutral table support stem, or in the far-infrared oven slowly. Since even dry neighbor drying or drying, the whole process should not take FAG bearing rings, adhere to any framework or rolling. FAG bearing oil delivered before the test in practice can remove the oil seal packaging, and immersed in the acid-three percent of kerosene or gasoline to clean.
2. Check the oil drops and request immediate delivery has dried or dried FAG bearings. At this time no film to protect the outer surface of the bearing, the whole process of inspection personnel are not allowed direct contact with the skin, the operator should wear clean gloves, hand painted with rust, but must avoid rust mixed FAG rolling bearings the appearance of the hands, otherwise it will measure the deviation of the results.
3. Should be served immediately or rust stock deal, the whole inspection process should be completed after the check FAG bearings. Time is too long, to avoid corrosion. Note the use of pure clean oil-free gasoline, can also cause corrosion.
   4. FAG Bearings has dried or dried, should be required to check no FAG bearing oil film to protect the outer surface of oil drops and instant delivery, this time, the entire inspection process, do not allow direct contact with human skin, the operator should wear clean gloves, hand painted with rust, but must avoid FAG rolling bearing surface rust mixed hands, otherwise it will measure the deviation of the results.
   5. FAG Bearings check is delivered immediately after the completion of the inventory process or rust and seize complete the entire inspection process should not last too long cause corrosion. Note the use of pure clean oil-free gasoline, can also cause corrosion.
   6. Before the test, also printed some of the usage of block co-located premises of standard parts and measuring instruments, metal inspection plate check, so that these objects can be quickly and room temperature homogeneity.
   Obviously, only strictly do the preparatory work to ensure accurate test results, FAG bearings throughout the inspection process will not rust.

FAG bearing rings are not permitted finished grinding burn and grinding cracks exist, especially with the inner surface may not have a screwdriver degree burns. If the rings should be pickled full inspection, product excised burns, severe burns can not rework or repair defective should be scrapped, not allowed into the grinding burn ferrule assembly process after the storage of steel ferrule before grinding, the process must be strict management and strict distinction between two different materials GCr15 and GCr15SiMn materials and products. ,
Are FAG Bearings can be judged according to the degree of damage in a variety of considerations, and in this respect the main consideration is the effect of injury, mechanical aspects of the performance, importance, installation conditions are to be considered, until the next overhaul the effect of the decision during which, but for the defect can not be used in the case, must be replaced with new bearings, the inner ring, outer ring, rolling elements, any holder of a crack on the gap is to be noted that this in this regard also maintained an effect of it. It is also a skill sense, the following is from eight to introduce rules.
After rolling bearing under load, plastic deformation in the rolling element and raceway contact points. The load is too heavy, it will form the raceway surface plastic deformation pits, leaving FAG Bearings summer produce strong vibration and noise during operation.
Dust and dirt due to the relative motion of the rolling elements and raceways invasion of the rolling elements and the raceway surface wear. Wear is large, the bearing clearance, noise, vibration increases, reducing the running accuracy FAG bearings, thus directly affect the accuracy of some of the host. So some of precision machinery used FAG Bearings, FAG is available to define the amount of wear of the bearing life.