We can provide free samples . Please contact Email for any inquiries

1 air hammer

Air hammer, by the working parts (piston, rod hammer and anvil iron), power transmission parts (motors, pulleys, Qu Shui shaft, etc.), manipulation of the part of the body (compression cylinder, cylinder, column and base), crank the rotational movement of the shaft so that the compressed air in the cylinder to be compressed or expanded, and this air through the airway and communicating to control the airway valve between the working cylinder and compression cylinder, the upper or lower chamber into the cylinder, thereby controlling the movement of the hammer rod .

Air hammer to the production of a bearing ring forgings, mainly small quantities, larger ring forgings, free forging hammer forging work suction and exhaust noise.

2 crank press

The crank press work organizations (crank, rod, slider) drive system (motor, pulley, drive shafts, etc.) and body composition, motor through a pulley to the crankshaft rotation, the crankshaft crank through even The rod drive slider for vertical movement, thereby performing work.

The crank press is suitable for sheet metal stamping, swaging the ferrule forgings (especially the production line), etc..

3 Rolling Machine

Rolling machine with working parts (rolling wheel cylinder, rolling roller), the control part (signal roll, valves, control systems, etc.), and body composition. Ring blank in the work set in the rolling roll the the rolling wheel spinning pressure in the cylinder pressure to the ring blank, with ring blank after contact began deformation, ring billet and rolling roller rotating in the role of friction the ring blank by compression and wall thickness, diameter enlargement, increased the outer diameter of the ring blank roll in contact with the pre-adjust the position of signal, the signal roll signals, cylinder switch up the rolling wheel backhaul unloading mechanism launch of the forgings, the completion of the ferrule rolling technology.

4 forging furnace

Heating on the intrinsic quality of the forgings, material utilization, production efficiency, energy consumption, working conditions, labor intensity, and environmental protection have great impact. Heating the quality is good or bad, depending on the structure of the heating equipment and the type of fuel. Domestic furnace fuel type can be divided into a coal stove, oil furnace, gas furnace and electric furnace four, which accounts for half of the entire production the coal stove production of forgings, less than 10% of the electric furnace.