We can provide free samples . Please contact Email for any inquiries

(1) fixed feed retraction mode

The turning tool from the tool change with G0 mode movement to the feed points, feed point in X and Z both directions away from the workpiece a certain distance, too far too close to not. Too far from the G01 feed air travel will increase, resulting in low processing efficiency; too close will increase security risks. Feed (from the knife point to the processing starting point) must be in G01 feed, the retraction must be retreated in G01 mode retract point (retraction distance artifacts at a safe distance) before movement in G0 .

(2) tool change settings modular

Tool change settings related to the processing efficiency and security issues. Tool change points are located too far away, and the tool from the tool change point motion to the feed point of time will be longer, reducing the efficiency; if too close, when a tool change may interfere and the workpiece, resulting in the tool, workpiece and damage to the machine. Therefore, set the tool change point, that point can be located near or far, so I use subroutine based on the actual situation of the tool and the workpiece fixed tool change, tool change only the tool back to retire knife point, and then call the subroutine can, so that the accident rate is greatly reduced.

(3) develop a standardized debugging action