We can provide free samples . Please contact Email for any inquiries

Before installing this equipment should be fine inspection of parts, today we talk about the important parts in the operation of equipment IKO bearings, fine inspection of the installation money.
Check the bearing all the parts and remove the flash all. Clean shaft and shoulder, and measure the shaft and bearing housing tolerances and shape. Check the oil seal, please contact the seller. Opened before installing the bearing. Try to ensure that the IKO bearings from dust pollution.
   

In addition to the bearing bore and outside surface. Other parts of the rust inhibitor does not have to wipe off. Easy to use oil and solvent in dry cleaning. The large bearing surface is usually sealed with a thick layer of fat like rust inhibitor. Before installing, cleaning method available to be removed.
   

Spacious and clean workplace, under normal temperature conditions, with the correct installation methods and tools. The installation site should be metal-free sand, cement powder foreign body. If possible, it should be installed IKO bearings section moved to the refurbishment of the factory. If once opened can not be immediately installed, the machine should be covered up and to keep the bearings from the pollution of the surrounding environment.
   

Bearing package and packaging are the best, before installation, open the packaging. Bearing bore and the outer surface with a lint-free cloth to clean. Note Do not use cotton waste cloth. And those who will be very low or very high temperature grease, synthetic grease lubricated bearings should be completely clean in order to avoid an adverse effect on anti-rust traces of lubricant performance.